Measuring tapes: draggable, shown in feet (needs scale set).
Tilted-rectangle gridding: draw a rectangle, "Grid this rectangle" — the chakra + grid follow its tilt.
Undo & saving
Unlimited undo + redo buttons.
Export / Import project (.gwproj): back up a project or move it between devices.
Export the finished grid image (markers hidden) for reports.
265° Chakra Gridding
GPS-CALIBRATED CHAKRA GRIDDING
1Layout & project
If the plan is portrait but should be landscape (or vice-versa), rotate it here before gridding.
Got 3 separate floor PDFs? Upload the first normally, then “Add floor” for each of the others. Each floor keeps its own gridding; the combined export covers all floors.
Export a project (from “Open saved”) to back it up or move it to another device — or to send it to your developer if a file ever opens wrong.
PDF & images supported. For DWG: export to PDF from your CAD software, then upload.
2Scale — 5×5 ft grid
Click the two ends of any wall whose real length you know, then enter the length.
Not calibrated
3Boundary & centre
Click each corner in order, then Close. Lines auto-straighten — tilted lines are never produced. Afterwards: drag any corner, drag any blue rectangle edge to override the 50% rule, drag the red centre dot.
Divide one layout into parts — grid each boundary separately on the same map. Each part keeps its own centre, degree and notes.
No boundary yet
✎Free drawing on layout
Draw freely on the plan — these are NOT auto-straightened. A faint guide shows whether a line is straight; you decide. After drawing, click a shape to select it, then drag its corner to resize or its top handle to rotate.
Anchor symbols — tap one, then tap the layout to drop that figure (WC, bed, stairs, lift…). It lands selected: drag to move, corner to resize, top handle to rotate. Uses the colour chosen below.
No drawings yet.
Grid a tilted area (independent of Step 3)
Use this when a construction area sits at an angle. Draw a rectangle over that area with the Rectangle tool, select it, type the degree that fits it, and press “Grid this rectangle”. The chakra is placed on that rectangle at your angle — the main Step 3 boundary is ignored for this part.
Draw & select a rectangle to grid it at a tilt.
Measuring tape
Draw a line anywhere to measure it — drag either end to move it, and it shows the live length in feet (using your set scale). Toggle all measurements with the “Dimensions” button above.
No measure lines yet.
4Degree (Google Earth)
Click 2 points along the measured wall (auto-straightened), enter the heading — the exact degree locks onto a perfectly straight perpendicular from the centre. Or grab the wheel's outer ring and rotate by hand.
Wheel rotation: — · drag the ring to rotate
North not set
5Display
Brahma circle with the 265° chakra and the four devtas always stays. Switch off Centre lines for the clean client export.
Zone suggestions (for active part)
Write a recommendation for any zone — it appears inside that zone's pie. On the layout you can drag any note to reposition it and use its small round handle to rotate it.
No suggestions yet for this part.
Entrance suggestions (32 entries)
Comment on any of the 32 entrances — its pada segment highlights and the note appears at that entry.
No entrance notes yet for this part.
Devta marking (for active part)
Pick any devta — its cell on the wheel fills with colour. Add an optional note and it appears as a draggable tag (drag to reposition, round handle to rotate), exactly like zone notes. Change the colour or size, or remove, from the list below.
No devtas marked yet for this part.
Room placement → Scoring Report
Mark where each room sits, then export a report file to auto-generate the Vastu score in Command Center.
Pick a room and click “Place on layout”. The room stays selected — keep clicking to drop more of the same room. Press “Stop placing” or pick a different room when done.
